Search results

I sent him an email and am waiting for a reply if he has inserts to fit my DCMT holders

I tried looking up Cobalt inserts and couldn't find any info. My holders are DCMT

What would be the best carbide inserts and techniques for tapering barrels to a sporter contour on a Harrison M300 Lathe

Could you recommend one? I've been watching some from China on Ebay and am curious if they're any good. I need one for 3 PH 3 HP 220V single phase input. How about the Teco L510-203-H1N? Pete

Is there a quick change tool post holder that will fit a Harrison M300 lathe?

Look up Loctite 420, it's used for prepositioned metal parts and is thinner than water

wiring when I connected my solid state 220 V phase converter to the lathe's 3 phase wiring I get nothing, but connected directly to the motor independently the motor runs. Am I missing or doing something wrong? Would swapping around the leads have anything to do with it?

I checked the Hub with a dial indicator and there's just about 0 runout. The 3 jaw chuck is a 3 pin camlock that I assume came with the lathe.

Runout What would acceptable runout be on an M300 lathe with the 3 jaw chuck? I had to disassemble and remove the dried white grease because the jaws were frozen. Wire brushed all the parts with a soft wheel, lubed and got it back together

What is VFD? and where can I get a manual for it, I mean a manual for the lathe

Harrison M300 /DoAll 13" lathe Anybody have any experience with a Harrison M300 13" lathe? I believe it was manufactured in England. Also has a DoAll 13" sticker on it. Also has a 3HP 3PH motor. I would like to install a 220V solid sate phase converter and wonder if I should bypass all the...

3M Scotch-Brite 4AVFN

pattern Give Evans Compton in NC a call. He has over 1500 patterns (336) 766-0271. He does stocks for Baiteys in N, Wilkesboro NC

barrel polishing I finally found a very fine soft convoluted polishing wheel that gives me the results I was looking for

barrel polishing I finally found a very fine soft convoluted polishing wheel that gives me the results I was looking for

What is the correct angle of the butt in relation to the centerline of the bore when building a rimfire benchrest stock?

I need help trying to ID a barrel I acquired. It's in the white, although magnetic it dosen't blue so it's probably some kind of magnetic stainless. It's bored and i threaded but not chambered and has a fitted thick Rem 700 type recoil lug. There's red paint on the muzzle face, and faintly...

Scott, what I'm trying to achieve is the finish Winchester put on the pre 64 70's. I'm trying to blend in rusted and pitted areas that I've draw filed and polished smooth but don't want to do the whole barrel. I've tried fine emery, 400 wet & dry and even a fine stainless carding wheel but can't...

Has anyone had any experience using a soft , fine abrasive Convoluted polishing wheels on a barrel before bluing? I would like to know what type of finish it leaves. I know they're made by 3M , Norton, and others, and are offered in soft, medium and hard variations, with fine, medium, and...

No doubt , it IS a CMP gun