Search results

I've got some Hoppes gun oil here and some Eezox but wasn't sure if I should put anything on the firing pin or spring. Concerned about it gumming up.

I'm going to be pulling the firing pin assembly out of my 40x rimfire to do a good cleaning. I was thinking about using some non chlorinated break clean to spray it down and wipe it off. Is this a bad idea? Also should I lube the pin and spring with anything before reinstall? Thanks

I've got a 1959 40x with a factory barrel that has been recrowned and have a Harrells tuner I want to use on it. I also have one of the longer weights for it . What's a good way of finding the right setting? It was suggested to try Purdy Prescription as a starting point. So I read up a bit...

I thought I seen they were only going to use them to replace moving backers? If so it doesn't have to be accurate , it just needs to record the amount of shots on target as they are still scoring the card manually. I think they can be great for fclass in the respect it helps keep older shooters...

I've not heard of benchrest shooters neck sizing only for years. When I started down the road to build my 30br everyone said full length size every time. All the 6ppc and 6BR guys I talked to said the same. As for dies most of the locals here have had good luck with off the shelf Redding dies...

Do you start with the bullet in the case just enough to hold it? Do you you use the same bullet for the whole process? Do you move back .001 each time?

So basically your wanting to find the spot where the bullet is just touching the rifleing then add .020 to .030.

How much neck tension? .003-.004? and how much Jam?

I recently picked these up and I believe these are the 10 ogive on 1inch jackets? Can anyone verify it?

There have been a few different 30BR reamers made over the years. But I believe there has only been 2 Official Robinette style reamers . His Original and now his revised JGS version but I could be wrong.

Mine was specd at .331 neck and .4715 at the .200 Datum.

They are a small family run business from what I can tell. Whenever I got ahold of anyone they had just come in from the machine shop. I have talked to 1 brother and a brother in law I believe and it's the sister that does the bookwork I believe.

I'm not sure about the whidden dies but I think they do. I know they do in a Harrells die. Harrell are great to deal with. I didn't have any fired brass to send them so I bought a #3 30br die and they said they would swap it out if needed once I got the rifle together. I've also bought rings...

Do you offer any of the 2500x actions as a LBRP? Also any Canadian importers?

Have chronographed any Lapua? How does it compare to Eley as far as SD and ES goes?

I can get some BiB's from a fellow shooter, Not sure which ones yet. I would have to find out which ones he has. I think they are the 118gr but not sure which ogive. Berger's shouldn't be too bad to get. Ive got 50 Sample bullets from Stinger Ballistics from here in Canada to try as well. They...

Its getting the final inletting and bedding done now.

Anyone notice much difference with a 7 ogive in a .925" jacket vs the 1" jacket?

What is your honest opinion on steel dies? I know you have a great reputation for your carbide dies. Also any opinion on 7 ogive vs 10 ogive?

After seeing Al's post of his bullet testing, I was wondering what the major disadvantages of steel dies are. I'm wanting to get into making my own bullets for my 30BR and am debating between 7ogive or 10ogive using a 1" jacket. So what I'm wondering is will a steel die make as good of a...