mikecr,
I think you are really reading way to much between the lines on this. I guess the best way to look at the meaning of this statement is to not make it an either/or statement as you are tending to do
(In fact, it specifically portrays BC as insignificant(which is rediculous). I agree that is rediculous and stated that in my above post.
This statement actually has four different results and not two. If you think of it like this then I think it will be really clear.
The 4 results are:
#1 bullet with high BC and is accurate in your rifle
#2 bullet with high BC is less accurate in your rifle
#3 bullet with lower BC and is accurate in your rifle
#4 bullet with lower BC is less accurate in your rifle
You can rule out bullet #4 altogether. I would select the most accurate bullets from #1 or #3 (and not #2) based on which one is the most accruate in my rifle. And BC wouldn't be part of that decision unless they both shot the same. Then I would select the higher BC bullet.
If you have a high BC bullet that is built with uniform jackets and put together by a good bulletmaker it will win. But you can't reverse that statement and have the same result. Meaning you can't put together a less than top quality bullet with a higher BC and still win the same amount of the time. That is all that statement says. No more no less.
Getting back to the original question(s) posted by silverback I think Matt Dienes' reply pretty much summed it up. You have to find the bullet that shoots in your rifle and BC shouldn't be the defining part of your decision knowing that long range bullets that are available come within a BC range of approx .5 or above to begin with.
JLK and Berger have cosiderably higher BCs so why do people talk so much about SMKs. Being they are all high quality?
Silverback,
Bullet Lots change even within the same manufacturer. Sometimes they are good, sometimes they simply don't shoot as good as the last lot. It happens to all manufacturers at some point. Sometimes it's not the makers fault. Ever think about what happens to match bullets during shipment across country? They may not be as uniform as they were when they came out of the point-up die.
I had a barrel on my LG that I couldn't get to shoot very well. I ended up trying some older 140gr SMK I had and it shoot a lot better with that bullet til I ran out.
That bullet simply worked at that time with the barrel/load/twist setup I had. A newer lot of the same bullet wouldn't give me the same results I got from the old mid '90s lot# I had shot before.
Steve