Where can I rent a 6.5-25WSSM Reamer...

L

LivetoHunt2008

Guest
...I have searched high and low across the internet....anyone here who had/has a 65.-25WSSM reamer I could rent!

Looking for a 0.300" neck..

Thank you.
 
Livetohunt,

You might want to look at a plain old 25 WSSM reamer. I think SAAMI says 0.298" neck. This is from memory and that becomes less reliable by the moment so if I check later and find out I'm wrong about that I'll edit my post and pretend I never said it. If you turn the case necks on your brass to a little over .015" you'll be in the zone for clearance. Mark King cut a chamber for me and a few others. They had good success but I quit in frustration. Too much trouble for 260 Remington ballistics but with a razors edge tune.

Greg
 
Last edited by a moderator:
LivetoHunt2008 said:
...I have searched high and low across the internet....anyone here who had/has a 65.-25WSSM reamer I could rent!

Looking for a 0.300" neck..

Thank you.
Click to expand...

I have a reamer with a .301 nk, I have a smith that I prefer to use it, if interested you can pm. Throated for the 140 class bullets.



Ron Tilley
 
Why not start with the 25 WSSM reamer, put a 6.5 floating bushing on it, get a 6.5 neck (correct size) and throat reamer and there you go. Am I looking at this correctly? You want a 6.5 caliber round based on the 25WSSM case necked up, correct?
 
that would work....I spoke with my gunsmith this afternoon...he said the same thing!
 
You must log in or register to reply here.
Back
Top