Turbo Action Firing Problem

J

JohnnyLorick

New member
I have a turbo action and I am having firing problem. The headspace is .042
Sometimes it shoots the 1st time then next it may fire the 2nd or 3rd time.
I have already replaced the firing pin spring and didn't help. I have a cone chamber barrel. If anybody can help with this, please reply. Thanks Johnny Lorick.:confused:
 
Be sure the bolt is very clean, inside and out. I used to have a bit of trouble when it was cold. I keep my bolt cleaner than I used to now and don't have any trouble. Did you order your spring from Flash?

John M. Carper
 
Are the case indentions consistent? If so, can you post a picture?
 
Picture

If you can twist and uncock bolt and show pic of firing pin extrusion and fired case,and were you told it was .042 or did you check I recently had same problem fixed it with firingpin and spring both were light ,firing pin may be short and on old turbos you had to slot trigger hanger and cock pin back further.
 
pin check

Pull Pin and check it for and burrs or to see if the tip has mushroomed any. They sometimes can flatten on the tip. I so it may not be sticking out far enough.
 
Trigger

Sometimes, the trigger can cause this problem. Flush the trigger with lighter fluid and do not put ant oil in the trigger. It must be dry.
 
You must log in or register to reply here.
Back
Top