Trimming and Deburring?!!

[John S]

I am using a Wilson case trimmer and a Wilson case mouth 30 degree deburring tool.

There seems to be a ridge left inside the case neck after deburring.

Reversing the direction of the deburring tool does not remove the ridge.

The cutting tool may be rolling up this ridge. I have not found a way to avoid it or remove it.

Any ideas?

Thanks

 

[jackie schmidt]

The tool might not be ground correctly. It sounds like the cutting edges don't have enough back clearance. I have an old RCBS tool that does the outside and inside, and after 50 years it still does the job.

Since the tools are not that expensive, I Just get another tool.

 

[GASTX]

The tool might not be ground correctly. It sounds like the cutting edges don't have enough back clearance. I have an old RCBS tool that does the outside and inside, and after 50 years it still does the job.

Since the tools are not that expensive, I Just get another tool.

What Jackie said!!

I use a wilson trimmer for case trimming but use the same RCBS deburring tool as well

 

[John S]

Thanks!

I'll try the RCBS tool.

 

[Zebra13]

John,

Lemme look around...I may have an extra RCBS deburring tool.

Justin

 

[jlcprec]

Get a repairman's reamer. T handle and a lot of taper, not 30 degrees.

 

[John S]

Justin,

Thanks, I have one.

John