Reamer print inspection?

[TrxR]

Could you all look at this print and tell me if you see any problems or any changes that should be made?

Thanks

 

[jackie schmidt]

Could you all look at this print and tell me if you see any problems or any changes that should be made?

Thanks

Assuming this is going to be used in VFS, it looks pretty good.

It will use a trim to length of around 1.510, the .331 neck should clean up just fine. (Mine is a .330 neck).

The zero freebore will be just right for 112/118 grn bullets, the 1.45 lead is in keeping, (I think), with Randy's original concept. I use a 1.30.

The diameter .200 from the bolt face looks correct for Lapua brass.



Looks fine.

 

[TrxR]

Yes this will be for VFS.