Boyd Allen
Active member
Use a two stage sizing process with a body die set for a MEASURED bump, plus the Collet die, and your hard bolt closing should no longer be a problem.
D
dmschmidt
Guest
thanks, will try this weekend!
Boyd Allen
Active member
What is the diameter of the loaded neck. over the largest diameter of the bullet? In other words I want to know how much neck tension each method is producing. Bottom line, your targets should tell you, although there are other variables. Lee will sell you mandrels in smaller diameters. When I was helping a friend with his, I had him order two, one each .001 and .002 smaller than standard, so that he could play with different amounts of neck tension.
R
retired
Guest
1st post on a 9 year old thread.
should have just started a NEW thread
answer:
we cannot tell from your question.
is the brass necked turned ?
if not it will be hard to answer
what is the neck dia of a loaded round with THIS brass ?
you need 1-2 thou under bullet dia on the inside, 1-2 under
the loaded round od.
should have just started a NEW thread
answer:
we cannot tell from your question.
is the brass necked turned ?
if not it will be hard to answer
what is the neck dia of a loaded round with THIS brass ?
you need 1-2 thou under bullet dia on the inside, 1-2 under
the loaded round od.
Wilbur
I already have one traffic ticket from him on another thread in another forum. he may be a retired police officer?
I already have one traffic ticket from him on another thread in another forum. he may be a retired police officer?
