B
Brian Voelker
Guest
Has anyone made a 30 degree shoulder reamer yet and I am assuming that it will make the volume requirement with that change. Looking ahead.
BV
BV
David Halblom
Flying Fish Fundamentals
not that I have heard of. It is too new
David Halblom
Flying Fish Fundamentals
it is also damn close to the 30x284 cartidge that George Myer pioneered
Pete Wass
Well-known member
30 ar 30*
Yes, one of the posters here had one made last year at Kiffs. He sent me the print a few months ago. They should hevae his print there. He sez it allows enough water to make the law.
I have a 30-284 X 1.650" and while close to the 30 AR is a bit longer. If I didn't have 350 cases made up for the one I have I might tumble for the 30AR.
Yes, one of the posters here had one made last year at Kiffs. He sent me the print a few months ago. They should hevae his print there. He sez it allows enough water to make the law.
I have a 30-284 X 1.650" and while close to the 30 AR is a bit longer. If I didn't have 350 cases made up for the one I have I might tumble for the 30AR.
Eddie Harren
Member
According to Remington, the case capacity is 44 Gr. and the shoulder is 25 degrees. With a listed neck length of .305" even if the shoulder angle is changed, to 30 degrees, there should be enough neck left to move the shoulder forward a tad to increase capacity. Now, if the brass is any good.......!