Q
Quentin
Guest
Thanks for the input and advice to you all,
Can you help me with this please?
I have applied a die to the round and finger seated it which shows the impession of the land of my firearm (243 ruger). I have then inseted the same round (very carefully) into the end of the barrel. I note that there is a discrepancy of about .75 of a MM. Does this then tell me that the barrel is tapered or again, may I be in error in my calculations?
Regards
Quentin
Can you help me with this please?
I have applied a die to the round and finger seated it which shows the impession of the land of my firearm (243 ruger). I have then inseted the same round (very carefully) into the end of the barrel. I note that there is a discrepancy of about .75 of a MM. Does this then tell me that the barrel is tapered or again, may I be in error in my calculations?
Regards
Quentin