300 Norma Reamer?

[Rubicon Prec.]

I've no components on hand to measure but I need to get a reamer offered for my personal project. It seems everyone I have asked has had a greatly different opinion. Is there any consensus here on an ideal reamer for a no-neck turn 300 Norma brass with 230 Bergers in a CIP mag?

 

[jackie schmidt]

I've no components on hand to measure but I need to get a reamer offered for my personal project. It seems everyone I have asked has had a greatly different opinion. Is there any consensus here on an ideal reamer for a no-neck turn 300 Norma brass with 230 Bergers in a CIP mag?

If you are ideally locked into that bullet, (that is a long bullet), the best thing to do is seat a bullet into a case exactly where you want it, and get a reamer designed with a throat that fits that long of a bullet. Also, measure the neck, and just add .004 to that, and have the neck of the reamer ground accordingly.

Maybe this reamer is close. You could get it as well as a throater, and custom fit the length for your round.


http://cdn0.grizzly.com/specsheets/t23220_as.pdf