Search results

They've got one at my local Academy so I'll get it there, and save my receit then I can take it back if need be and I agree, life is short Thanks! :)

Thanks for the tips, I'll try that and then see if I can blow most of the residue out of trigger/action with my air compressor before I lube everything. :)

I've noticed there is quite a bit of the dark brown color on the metal and was wondering how most of you remove it without, taking the gun completly apart? Thanks for all suggestions! :)

Not sure, where I'll buy it from yet but Thanks! :)

Anyone know if this mag will work in this rifle? Thanks! :) https://www.smga.com/savage/110-tactical-desert-65-cm-5-824-24-b-2703 https://www.opticsplanet.com/v/mag549-blk-magpul-industries-pmag-5-7-62-ac.html

Is this a common problem with this model when new? Or is there some sharp areas that need polishing in the receiver? Since I plan to reload for this gun that's not something I like to see on my casings. Any tips to safely, polish or lap etc. the receiver to cure this problem would be greatly...

I guess I can use a q tip with a little case lube to lube the inside of case neck? I'm pretty new to reloading sorry about all the questions.

I assume you remove the de capping rod in order to grind?

I've managed to tighten the die a little more by hand and bump back .001" the bolt seems to close fine now. Thanks!

I have the die screwed all the way down against the universal shell holder per setup instructions. The problem is, I need just a little more shoulder bump is anyone familiar with this Forster Coax press and know how to gain more shoulder bump when the die can't be screwed down further to get it...

I'm reloading for my Savage 10fp in .223. I am using a Forster Coax press with the Forster Benchrest die set. My loads with new brass chamber and bolt closes easier, than the rounds I used the FL sizing die on. What do I need to bump the shoulders back .001-.002"? or can the FL. sizing die be...

I don't think, it's a fouling problem since the gun has only had about 100 rounds through it. Also,it has been cleaned twice besides the through, cleaning I gave it after taking it out of the box before first shooting. Thanks!

Will do, Thanks Folks!

Does anyone else with this model or similar, find the bolt hard to close on most but not all, rounds of Wolf Match target ammo? Also, some rounds I have to push pretty hard just to push it fully into the chamber before,,I can close the bolt do I have a feeding problem maybe? the cheap federal...

I plan to load a few rounds tomorrow for starting loads. I checked the Hogdon Data online calculator and it suggested 47grn. and around 50grn. max. The thing is their load is for the Nosler Part . Should I still, use those same starting and max charge although I'm using a different bullet but...

I dug up a bunch of older cheap factory loaded .223 brass of different brands and found some of it to measure as short as 1.736-1.737" so, I think I will fire before trimming. What about lightly deburing inside and out before seating bullets? Thanks!

Thanks for the advice folks!

Is new brass always the proper length or should each case be checked? My Lyman book says trim to 1.750" for the .223 rem. Does all of the brass need to be trimmed to the exact same length if a little over or, does small differences not matter as far as accuracy goes? Thanks! :)

Thanks very much!

I received mine today along with .223 insert but, without any instructions. Anyone know of a link to a user guide etc? Thanks! :)