Search results

my 10x 22 broke an extractor, I have tried to contact 10 x but no answer. I need a set of rimfire extractors, If anyone knows where to get a set.. Thanks Also I think 40x rimfire extractors will work.

Rusty Stud, It is thickness difference of the 223 bolt head and the Mag,, The 223 just screws into the receiver deeper than the 300WSM does by about 138 thou.. I almost always fit the barrel with a shoulder like a Remington, I like it better. I will try it Thursday and will give a report then...

I leave about 3 to 5 thou between the bolt face and the barrel. I chamfer only about 1 thread, not 1/8 on an inch like recommended. This is to gain barrel/receiver contact.

nhkuehl, Here's the mic measurements from the rifle I am working on. The 223 from the face of the action to the bolt face is .703<> the 300wsm measures .565. So I have 138 thou less threads in the receiver. Just thinking about the pressure of the mag and less receiver holding the pressure.

Jim, Is .563 enough for the Mag pressure, it probly will be but I was asking someone like yourself that might have done the Mag conversion. I have rebarreled probly 100 barrels with the standard thread engaugement of about .800 thou. But never with a lesser thread engaugement.

I am building a 300wsm on a Savage target action that was a 223. My question is because the bolt head on the 223 is about .435 thou. thick and the 300wsm bolt head is about .568 thou. thick I am going to have about .138 thou less threads screwed into the action, Is that enough to hold the...

How do I get in contact with (RICH) Thanks

Found one with RWS $450.00 New gun 325 ??????????????? Wont be buying from RWS!! Maby buy a Daisy. Walther is to get back with me.

tried both, no go.. still need a barrel for my RWS model 52

Where can I buy a new barrel for my Diana RWS 52, condensation from not cleaning properly has pitted the bore beyond lapping out.

OK, I rethreaded the bolt and tapped the barrel to 1/4 28. Where is the best place to get the gunsmith sizes of tap sets, if someone could tell me.. Thanks in advance

The forarm on a Martini 22 rifle has a retaining bolt that mic's .250 and is between 28 and 32 TPI.. Does anyone know the the tap that I need...Thanks.

Tim, PM me your adderss, I cant make it out on the package.. Thanks

Sent you an email, That is it.

Thanks Tim,, A 64 action firing pin is suppose to work.

Firing pin is splintered on the end, causing mis-fires. Realy need new firing pin. I will re head space it when I find new pin. Thanks..

Still need firing pin for 164 Anschutz.

Still need 164 firing pin. Thanks, I've have it taken care of.

I have searched for a firing pin for my 164 sported, Do any of you know where to find one? Thanks..