T
Tim Mn
Guest
Can someboy tell me what dies I need to get to get from 223 to 20 vt. Thanks
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
V
Vartarg
Guest
Redding
Redding makes a form die and a trim die.....to go from .223 to 20VT. I bought mine from Midway. It'll be in the 20VT section of their site, I believe. I"ve made about 400 from Lapua and Winchester, but wouldn't bother again as long as the Rem 221 FB brass is available....lot's of work.
Redding makes a form die and a trim die.....to go from .223 to 20VT. I bought mine from Midway. It'll be in the 20VT section of their site, I believe. I"ve made about 400 from Lapua and Winchester, but wouldn't bother again as long as the Rem 221 FB brass is available....lot's of work.
A
Armed in Utah
Guest
223 to Vartarg
I formed some 223 brass to Vartarg recently...very time consuming...used new 223 Win brass with zero failures...Rem FB brass sucks big time....
I formed some 223 brass to Vartarg recently...very time consuming...used new 223 Win brass with zero failures...Rem FB brass sucks big time....
Butch Lambert
Active member
I will have case forming die sets available in about 60 days. It will have 9 hardened die bushings. You can take the diameter of a 30-06 case down in size to a 14 caliber. You can stop at any diameter in between and can shorten a case to 1.100 if needed.
Butch
www,shadetreeea.com
Butch
www,shadetreeea.com