Turbo ejector question

T

Travelor

New member
My Turbo has just started to fail to eject cases every 5 sots or so. It will extract, but fails to eject. If I push the case downward the ejector when the bolt is brought rearward, it will eject.

Thinking worn ejector piece but ?????

Any idea where I could buy the ejector - it looks to a rookie like me that is is part of the loading platform.
 
What I ran into on mine...

The ejector was rounded off on the corner. I gave it some more life by using a Dremel cutoff wheel to sharpen it up on the front edge. When it started failing again, I found the ejector side extractor was not shaped properly...it was the same shape as the other side. After correcting that with a file, it had some more life before I replaced the ramp with a new one from Flash(would now have to come from DiOreo/Hinegardner). Since that time, I've decided the next one I wear out will just get a steel pin, positioned at the leading edge of the ejector, and glued into the ramp.

Jim
 
You must log in or register to reply here.
Back
Top