Seeking Help for Canjar Trigger Adjustment

D

doberman66

Guest
New to rimfire benchrest but hooked already. Acquired a rifle with a Remington 37 action and Canjar trigger and would like to learn more about it. So far learned the trick to bolt removal. Next is the trigger. Does anyone have instructions for the adjustment of the Canjar?
 
The allen screw directly in front of the shoe is WOP (CW for more).
Screw directly in rear of housing is sear engagement.
Screw and nut in front of housing is overtravel.

bjm
 
There should be a wire hanging down at the front of the trigger. With the bolt closed and FP in the fired position, push the wire upward and open the bolt and pull staight back all in one motion. To reinsert the bolt, I find that while pulling the trigger and wiggling the bolt, it slides in quite easily. Just practice a few times to get the hang of it.
 
Not on the 37 Fred only the 52. No wire here. You push the sear down from the top.

bjm
 
Thanks guys. Just one more step in the learning process.
 
You must log in or register to reply here.
Back
Top