repeater action rigidity

[Chet]

I am having a 6.5x284 x 30" 1 1/4' straight barrel installed on a Savage long action and it was a repeater. looking for some tips to keep it a rigid as possible, I do have a Farrel one pc scope base, i figured this would help, the stock is pillar bedded and action is bedded, going to bed a 2 inch area of the barrel about 2 inches in front of the recoil lug, any tips to make this set up as rigid other than what I plan to do.

Chet

 

[tim in tx]

chad sir

you can glue a follower plate into the bottom hole. but then i wont be a repeater,if it doesnt bother you to put each round in the rifle one at a time it will cost you about 10 bucks and will help significantly, a sleeve is probably the next option but the cost is pretty high i am sure.good luck sir tim in tx