I had my barrel chambered from a br smith that used his reamer. I have the ptg reamer print. I want to purchase my own reamer. Now, would the reamer that I get cut the chamber the same? Also, my freebore was cut in a separate operation. What throating tool would I need to manually throat in a separate operation? And how can I match the freebore? Trial and error with a seated bullet in a sized case?
Reamer questions
- Thread starter DSM
- Start date
L
luke wads
Guest
the best thing to do is send ptg a dummy round with the reamer print and ask them to set the freebore to the dummy.
or you can get thraoting reamer and adjust the freebore as you like.
or you can get thraoting reamer and adjust the freebore as you like.
J
Jan
Guest
How about making a chamber casting and sending that to PTG?
A
abintx
Guest
Go directly to the expert. Call Dave Kiff at Pacific Tool & Gauge. His number is at the bottom of this page: http://www.pacifictoolandgauge.com/. Ask him the best way to proceed. 
S
stevec
Guest
Go directly to the expert. Call Dave Kiff at Pacific Tool & Gauge. His number is at the bottom of this page: http://www.pacifictoolandgauge.com/. Ask him the best way to proceed.
YES! Dave is very good to help and answer questions.
Steve