New Hermes stylus regrind..

[eww1350]

Looking for some help..I have several carbide tipped cutters for my New Hermes engraver (rotary spindle) that need to be reground (sharpened)..who offers that service??
I am NOT looking to do them myself as I want several angles and tip diameters..

Thanks


Eddie in Texas

 

[Dusty Stevens]

i just buy new ones on ebay those angles are very tricky to keep the lines clean.

 

[Dave Tooley]

Craft Tools
21411 Bridge Ave.
Point Pleasant Beach, NJ 08742
732-899-4885

They do a good job.

Dave

 

[msalm]

http://www.antaresinc.net/

I've used their cutters in the past and have been very happy with them.

 

[Rustystud]

Looking for some help..I have several carbide tipped cutters for my New Hermes engraver (rotary spindle) that need to be reground (sharpened)..who offers that service??
I am NOT looking to do them myself as I want several angles and tip diameters..

Thanks


Eddie in Texas

You might look at these folks as well.

http://www.2linc.com/engraving_tools_diamond_tools.htm

Nat Lambeth

 

[liljoe]

I just bought a couple new one's from BitsBits.com. They were here in just a few days from the opposite coast and the price was very good. They offer a sharpening service also. I think it is $6 per. Just another place to look.

Joe Hynes

 

[eww1350]

Thanks for all the replies...very helpful..


Eddie in Texas