m-12

reshaped the stock, took about 4" from the forearm and several from the buttstock. reduced the rake and this winter will taper the buttstock and finish, in all took about a lb of wood off. it has been bedded and the pillers are of devecon. the area underneath the trigger guard is bedded and the pillers and action are one bedded unit. will see what this does to harmonics. bedding was done by Alex Sitman
 
Last edited by a moderator:
there is just the 1oz. adapter and tuner setting is 332. on this there were 2 speeds used 1060 and 1077 then the target was shot with team and a speed of 1054.
 
Here's my M12:

MVC-019F-2.jpg
 
I think you will agree that these rings make more sense!

Here is my most recent scope set up!
m12.jpg


This gun shoots!

Thanks for the help with my Anschutz Super Match!

Regards, Bruce
 
oldswede you have a very nice looking rifle there. Bruce your welcome anytime. the lop on mine has been reduced to 12.750 and overall length is 28.0 the rubber butt pad was replaced with an aluminum one. do you beleive placing a rubber spacer between barrel and forearm a result of the vianni mount inhibiting barrel vibration? even with a tuner this one has not experienced that, these are .900 diameter barrels with little taper?
 
You must log in or register to reply here.
Back
Top