Is There A need???

T

Tod Soeby

New member
I just sorted 4000 bullets (30, 6mm, 6.5) with my shiny new tool from Bill Shehane. LOVE IT :D. EXPENSIVE:eek: I was also thinking of buying one of those new bullet pointing dies. Maybe buy a machine and start to anneal brass.


I enjoy doing these things. But the cost of all my new toys is brutal.

Would there be a market in this sport doing custom work for other shooters. Would any of you "ANAL RETENTIVES" trust someone else to sort your bullets, point your bullets, anneal your brass, ect.... I have no Idea what to charge....it takes me close to three hours to open all of the boxes, set up the tool, sort and seperate in .001" groups, re-box/bag, lable everything, and tear down. My thoughts would be $30-40 per thousand. ?????....

Offer sorting by bearing serface (.001),
Offer bullet pointing.
Offer annealing of brass
Or a combination of above.

Again, just thinking out loud. Trying to figure a way to recoupe some of my expenses.

Am I totaly insane??;)

What are your thoughts.

Tod Soeby
 
Last edited:
i doubt u r insane... brass is offered weight sorted, and neck turned...go for it.
 
Tod,

Aren't your toys a business expense?

Sell another car, recoup your investment, and skip the extra work.:D

Or holler for a bailout........

Glad I could help,

Al
 
alf said:
Tod,

Aren't your toys a business expense?

Sell another car, recoup your investment, and skip the extra work.:D

Or holler for a bailout........

Glad I could help,

Al
Click to expand...

Buisness expence?.?.?.?.? Not untill I start selling you guys cars and trucks!!;)

Bailout....Haven't you guys herd.....Ford don't need no stinkin bailout.....besides...If the OBAMANATOR thinks he can run GM and Chrysler, he shur-n-L would try the same with the prized blue oval....That (among other things) would cause me to want to choke him untill HE looks like a blue oval!!:mad:

BUT I DIGRESS.:D

I am assuming that the match on the 18th is still a go.
 
Last edited:
Tod Soeby

Tod
It might work better if you sorted them for a wider bunch of operations than just bearing surface.I can see a Juenke machine in your future
Waterboy
 
Tod Soeby

Tod
If you can get one for $600 you better jump on it.Last time I talked with Vern he wanted $1265 shipped.
If you want to make it a business the equipment costs get spread out over time so don't worry about the initial outlay.Give the people what they want and it will work.
Lynn
 
You must log in or register to reply here.
Back
Top