goodgrouper
tryingtobeabettergrouper
Anyone know of a manufacturer that makes inside neck reamers that are round on the end and can be mounted on a Wilson Trimmer? I don't like the ones Sinclair sells because they are flat on the end.
inside neck reamers
- Thread starter goodgrouper
- Start date
JerrySharrett
Senile Member
I haven't seen an inside neck reaming process that leaves what I would call a suitable finish for benchrest needs. Inside neck boring on a lathe, properly set up, can can leave a good finish, but the setup process is a pain and the process is slow because getting a good finish by boring is slow.
Any good reamer grinding shop can grind what you want if you are willing to pay for it. Or, they can regrind your reamer nose to the shape you want.
Butch Lambert
Active member
Wilson sells inside neck reamers for their case trimming tool.
http://www.lewilson.com/products.html
Go to this link and scroll down. They make custom sizes.
http://www.lewilson.com/products.html
Go to this link and scroll down. They make custom sizes.
goodgrouper
tryingtobeabettergrouper
Thank you fellas. Much appreciated.