Cleaning up cartridge rims ...

A

abintx

Guest
I have little pieces of brass that have been pushed up on the edge of the rim of my cartridges at the extractor groove. I suspect it's from chucking brass into my drill bit holder or Lee brass holder used to secure it prior to spin cleaning necks. These little nobs of brass are annoying when trying to get brass to slide into a press shell holder.

Does anyone know of a tool for cleaning up the edge of the rim at the extractor groove ???

I once read an article by Speedy Gonzalez where he alluded to such a device but I could never track one down. Appreciate any info you can provide on such a tool. Art
 
Not high tech at all, but it would seem that a fine cut needle file of the correct shape could take these off as fast as anything.
 
You must log in or register to reply here.
Back
Top