Acraglass and bluing.

T

tjensen

New member
Hi fellows.
Does anyone have experience with blueing after acraglassing a liner in?
Can the acraglass take the heat/chemicals?
What about Loctite?
Thanks .
 
tjensen said:
Hi fellows.
Does anyone have experience with blueing after acraglassing a liner in?
Can the acraglass take the heat/chemicals?
What about Loctite?
Thanks .
Click to expand...
-----------------------------------------------------------------------------------------------------------------------------------
I use Loctite 620 or 680. 620 can withstand over 300 degrees, and 680 is closer to 280 degrees. I have blued both with no problems, but now stay exclusively with 620..620 has slightly less strength, but still plenty for liners.
I only line .22 pistols/revolvers.

Good luck

Jerry
 
Jerry Keefer said:
-----------------------------------------------------------------------------------------------------------------------------------
I use Loctite 620 or 680. 620 can withstand over 300 degrees, and 680 is closer to 280 degrees. I have blued both with no problems, but now stay exclusively with 620..620 has slightly less strength, but still plenty for liners.
I only line .22 pistols/revolvers.

Good luck

Jerry
Click to expand...

Jerry, this is a great reply! :)

Thank you for an informative answer

al
 
You must log in or register to reply here.
Back
Top