6x47 brass trim length

D

djp

Guest
whats the correct trim length for the 6x47 after sizing from 6.5x47 thanks
 
Best route would be to check the reamer print used for your chamber. My print shows a chamber length of 1.860", so I trim to at least .010" shorter than that.
 
I agree with flatlander. This is still a pure-dee wildcat, no SAAMI specs, therefore the only way to establish parameters is from YOUR chamber and YOUR reamer.

al
 
so you dont have the print ???

sinclair sells a slug that goes in a case( with a shortened neck) that allows you to measure the end of your neck in the chamber.

then 5-10 less than that depending how you load

mike in co
 
You must log in or register to reply here.
Back
Top