150 gr load using 308 Lake City brass for AR10

[Greg in UT]

Looking for a starting load using 150 grain Combined Technology bullet, 308 Lake City brass, Reloader 15 and 210M primers out of a 20 inch AR10. Thanks.

 

[mike in co]

go the powder makers site, look up the load, reduce by about 4% for the brass and work up.
if you can post here, you can look it up.

mike in co
(kinda lost on your choice of components...lc brass and ct bullets ??...what are you doing ?)

 

[Greg in UT]

Mike in CO

Thanks for the reply - I'll check out Reloader 15 load data. I had purchased bullets, brass and powder for an AR10; hunting load in case brass was lost. I'll load commercial brass and 168 SMK for accuracy at the range.