11 degree or 90 degree crown

3

30xs

Guest
Which should I go with. Looking to get a PTG crowm facing tool and can't decide on which one to get. Is ther any advantages to either one, other than the obvious recess in the 11 degree? Thanks. Tim
 
Used to be that the 11* crown help protect the crown of your barrel, but nowadays everyone uses a tuner, so a 90* crown would be just as good as the tuner will protect the crown.

JMHO

Dave
 
Thanks. No tuner. Just going to recut the crown on a factory Savage MKII and was looking for some insite. Not too worried about damage to the crown, but 11* may be te better choice. The cutter I was looking at is from PTG through Midway. The pilots are .217 .218 .219, are these the correct size for a rimfire, or will I need to order a smaller pilot?
 
crown

30x

go over to r/fire central there was a huge discussion there regarding this subject.

like everything else works for some for some it dont.

go to the search bar and type in crown

bob
 
You must log in or register to reply here.
Back
Top