Search results

Interesting, a side pic for a better view when you get a chance please. To add... I thought about facing off the inside (bag side) of the ears as well.

I've thought about them as well

.Will those L-bags bags slide into the T-Rex top, or would some machining need to be done ?? They will if not filled very tight. The support from the Rodzilla top firms them up once in the holder.

This is one of my Randolph tops that can accommodate an over 6" stock so the plate above will take these bags and side plates. It should center @ 4" but will be offset @ 6" then a stop will need fabbed up.

I have that bag holder /\ and have seriously considered cutting it in two to hold the L bags and space them as needed. This plate will take the individual l_ _l bags and the thinner Seb uprights/tensioners.

I agree with keeping it low, gonna be pretty hard to do though without off setting it though

It could be done running the bridge high enough to clear the elevation post. Then you'd need to elevate with shims or get a taller rear bag to lower the muzzle. All that can bring it's own problems. I'm going to put some miles on it as is and ponder it some but I agree it can be done.

@Fuj The threaded rod through the bridge?? A support or stop or ??? What prompted you to do this? I like the front sled/bag rider

I have all kinds of bag holder parts and was very close to building my own setup using a Sinclair holder and probably will yet. The biggest drawback for me is the lack of "real estate" up on the bridge because of the elevation gear post. It won't allow for a 6" bag holder which I've been...

Been a long cold winter up here but I had it out to shoot off Saturday When I got it I had to get the IBS legal top from Rod. Got a 2 piece joystick thinking it could be cot down on the skinny end Put together some bench type leveling screws and picked up a couple of 4" bags to try out. Made a...

I've heard the Micron bushings measure well. I've got a couple and have no complaints. All my record rounds and any test rounds get spun on concentricity tool to "paint" the front of the bullet with sharpie markers. The only time I put the indicator to them is if I see or feel a wobble while...

@GET There's a guy named Mark Johnson (I think) in CO Goes by majohnson on accurateshooter.com I know two very good LR shooters that had him go through their Farley's and are beyond happy with the results. Might be worth checking out. If I had a Farley it's the first thing I'd do.

Whiddens Gun works is always the first place I look for VV powders. Very competitive pricing shipping and hazmat IME Precision reloading also as mentioned

Anyone experienced with them? Any nuances? Tricks? Tips etc? I just got a new to me unit and will be setting it up and trying it out as weather permits.

Initially I thought it probably had more to do with pin fall and or shape/condition of the tip of the pin I'd bet. After looking at the pic I see it pierced on the edge so likely a defective primer but they are still flowing back around the pin it looks like.

So agging the Saturday & Sunday two gun points together to name The Two Gun Overall 16 target agg MN State Champion I get the following.... 1st Curt Knitt. 5 2nd Steve Hoskin. 9 3rd Greg Wahlstrom 10 4/5th Todd Zaun/Tod Sobey 23 6th Dave Huffman. 25 7th Robert Unertl. 33 8th Dean Kapphahn. 34...

Sunday results, some may be dated wrong but are in fact Sunday the 15th

Eric Sandhoff lays down one of the best looking smallest groups I've ever seen today .607" 50-5x

Day one results, my first tactical match. Harder than it looks LOL

Pulled into the range this evening. Weather/wind forecast not looking great for testing tomorrow.