Search results

With J-4 requiring the purchase of large number of cases of jackets does anyone know of any other source for 6mm, 1.050 jackets?

I built a neck turner with a Dayton 1LPV2 Gearmotor. It runs at 181 rpm, 1/20 HP, 12 inch pounds torque, 115 or 230 volt and has reversible direction. These motors come with a capacitor start which is recommended for this type of application. It is hard to find quality gearmotors that are...

Rick: You may want to consider attending a Peeking Groundhog Match at the South Fork Rifle Club located near Johnstown, PA. It is approximately two hours from Pittsburgh. They hold monthly matches starting in the Spring. Their website, southforkrifleclub.homestead.com/home.html gives a good...

The sheet from the Club which I have states: The match dates for 2019 are 1/12, 2/9, 3/9 and 4/13. UBR non sanctioned matches using the UBR targets. Matches are 100 yards. 10:00 a.m. practice with match starting at 11:00 a.m. Registration starts at 9:30 a.m. Unlimited/Benchrest Rifles (17 lb...

I had a problem with extraction after about 2 1/2 seasons on my 2500X action. I contacted Mr. Stiller and he suggested that I disassemble and clean the extractors and extractor grove on the bolt. I did so but the problem continued. I then changed both the spring clip and the extractors. So...

A number of years ago my dad who was in his late 80's lost his sight in his right eye, he was a right hand benchrest shooter. I purchased an offset mount from Robert Hart in Nescopeck, PA. It is made of aluminum and weighs approximately 6 oz. with an offset of 2 1/4 inches. It was for a Kelby...

The rest top and windage adjustment mechanism you have was sold by Sinclair in the early 1990's. The windage adjustment was used to convert a non-windage top to a windage top. If you move the windage wheel you will notice that you do not have uniform tension going both directions. There is...

rossi Tumbling for 30 minutes seems to be more than is needed to get a uniform lube coating on the jackets. I use a method for lubing 6mm, J-4 jackets that seems to work well for me in my carbite dies. I use a Tumbler's Tumbler Model B which is a large tumbler. I put the jackets...