Who makes a custom 6.5BR threaded FL die.

N

NeilNE

Guest
I need a 6.5 BR improved threaded FL die. It's for a 40 degree shoulder, with minimum taper. I have a seater die.
 
Gonna be hard to find. Who did the chamber? See if they have a resizing reamer and get a Newlon blenk. I used to use a Hornady 6.5 short neck sizer for mine before I got my die made. ANother choice is to send 3 fired cases to Redding and have them make a die.

Mike
 
Best way to go....

Send 3 or 4 fired cases to Neil Jones... His dies are the best.

Paul
 
Thanks for you help, I'll call Neil and Hornady and see what they have to say. Called Jim C., but I don't want to spend $225.00 for one die. Thanks again!!
 
FBecigneul, my problem is the base of case. I have a Wilson seater and neck size die. With this newly chambered, but used barrel, with a reamer that was just sharpened, the chamber is bigger. There for my die's do not work very well. Very hard to extract, from seater and neck size die.
 
Neil,
Take a wood dowell, cut a slit in it, slide in a piece of emery cloth, and polish away on the base of the dies till the brass fits.

Al.
 
Hi Alf, The other problem, seem to be having alot of these. I have another barrel for the 6.5BR, that my die work fine for. If I open them up, probably will not work for other barrel I have! I could do the seater, but worried about the neck size die.
 
Last edited by a moderator:
You must log in or register to reply here.
Back
Top