You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Rear bag info
- Thread starter REMY
- Start date
Rear bag
PMA tool sells a lenzi bag that is made just for the Scarborough and scoville stocks . I have one for my scoville and it fits like a glove. It is well made and you will like it . Call Pat at PMA and talk to him he will help you out.
Make sure you go ahead and get the stabilizer bag with it great combo.
PMA tool sells a lenzi bag that is made just for the Scarborough and scoville stocks . I have one for my scoville and it fits like a glove. It is well made and you will like it . Call Pat at PMA and talk to him he will help you out.
Make sure you go ahead and get the stabilizer bag with it great combo.
Last edited:
Michael Huebner
Member
Edgewood Bag
Yes have the new Edgewood with slick material overlayed
All good so far. The slick material will wear out over time so I would probably do Cordura overlay next time.
Michael
On the same note has anybody tried the new edgebags with the overlay ears ?
Yes have the new Edgewood with slick material overlayed
All good so far. The slick material will wear out over time so I would probably do Cordura overlay next time.
Michael
I've had and have
several Edgewood bags and generally like them. I do think, however, that there should be thicker leather in the bottom. Several of mine have bulged to the point they contact the table surface through the cutout bottom and rock. I had one that showed a slightly collapsed right side resulting in a canted configuration viewed from the back or front of the bag....sort of like this. Edgewood was great about it and replaced the bag. I think they would benefit from thicker sides all around. I've had no such problems with Protektor bags. Just my experience.
| /
several Edgewood bags and generally like them. I do think, however, that there should be thicker leather in the bottom. Several of mine have bulged to the point they contact the table surface through the cutout bottom and rock. I had one that showed a slightly collapsed right side resulting in a canted configuration viewed from the back or front of the bag....sort of like this. Edgewood was great about it and replaced the bag. I think they would benefit from thicker sides all around. I've had no such problems with Protektor bags. Just my experience.
| /