QC tool holder brackets

[adamsgt]

Within the last week or so I recall seeing some brackets to hold QC tool holders. I can't remember if this was in an email or just surfing the web. I seem to remember that they looked like two wedges mounted on some backing strip you'd use to mount them on a wall. If anyone else has seen these could you please point me in their direction?

 

[SET]

This is what you probably saw although it seems easy enough to make your own.

http://cgi.ebay.com/QC-quick-change...ork_Holding&hash=item53dd7dea5e#ht_1077wt_827

 

[adamsgt]

This is what you probably saw although it seems easy enough to make your own.

http://cgi.ebay.com/QC-quick-change...ork_Holding&hash=item53dd7dea5e#ht_1077wt_827

Thanks, that was it, although I didn't see them on ebay. I have bought other stuff from Alisam and must have been browsing their web site.
Since I hit 70 the memory is really starting to go.

 

[piniongear]

Adamsgt...........
Thanks for the tip on the QC holders Jerry!
I bought 4 of them and they arrived today.
Wow! Is that going to be nice to have them hanging on the wall behind the lathe instead of buried under 4 inches of chips and swarf in the lathe bed.
Thanks again......... Blake