Primer Removal

J

jim

Member
Need advice - I was priming some Lapua 223 brass and inadvertently inserted one of the primers in backwards - I assume OK to use a small punch inserted through the neck to pop it out?

Tx
 
I would do something to attempt to kill the primer first put it in oil/wd 40- let it sit for a while as some of the stuff they seal them with takes a while to soak thru . still- BE CAREFUL- WEAR EYE PROTECTION-but how much is one round worth versus the potential problems :confused:
 
Resize it with your regular dies. The die will decap it. I wouldn't use a punch usless you want to wake the children.
 
A drop of oil into the primer, them run it though your depriming die.

More than likely you would not need to put the oil in, but it is just a extra precaution.
 
just PUSH it out with a decap die......DO NOT PUNCH IT OUT.

no need to kill if you push...........
it is an IMPACT device....just push

mike in co
 
You must log in or register to reply here.
Back
Top