shooterjon
New member
Can anyone help me find a action wrench for a Hall model B action?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Need Help Finding Hall action wrench
- Thread starter shooterjon
- Start date
Steve Kostanich
Active member
Shooter
If you or a friend has a lathe and mill, it is a fairly easy wrench to make.
.870" dia. x 8" long, mill the front with a pair of flats slightly narrower then the bolt lug width, to fit into the lug ways cut in the receiver, then mill the opposite end to a 5/8 hex for a socket.
FWIW
Steve Kostanich
If you or a friend has a lathe and mill, it is a fairly easy wrench to make.
.870" dia. x 8" long, mill the front with a pair of flats slightly narrower then the bolt lug width, to fit into the lug ways cut in the receiver, then mill the opposite end to a 5/8 hex for a socket.
FWIW
Steve Kostanich
shooterjon
New member
Shooter
If you or a friend has a lathe and mill, it is a fairly easy wrench to make.
.870" dia. x 8" long, mill the front with a pair of flats slightly narrower then the bolt lug width, to fit into the lug ways cut in the receiver, then mill the opposite end to a 5/8 hex for a socket.
FWIW
Steve Kostanich
Thanks Steve While I DO NOT have a mill OR lathe I will try to find someone to make the Action wrench.
PS.You put together this 6 PPC and its a shooter.
Thanks again.
Shooterjon