hornady chamber length tool

yes... i believe the thread is 5/16 36....

made a bunch
 
thanks, that's what i meausured them to be. know it sounds like i'm being a tight wad but i'm talking about 15 different cases. should be worth the price of a tap and drill bit! am new here, will try to practice my typing skills so as tonot to rude or blunt. thanks again lightman
 
hi tony, ordered it from mill and mine supply in little rock, ar. you should have a simular type of industrial supply closer to you. good luck, lightman
 
A few months back I called all over Nashville and even had a couple of my employees looking and couldn't find one anywhere. I was hoping to find one on the internet but I will call Mill and Mine and see if they will ship it to me.

Thanks for the info.
 
make an expander....about 1 thou over bullet dia, i shoot a lot of cast bullets, can size them to use aas an expander. all else brass or steel rod turned or sanded down to size.

mike in co
 
You must log in or register to reply here.
Back
Top