I just purchased a 6.5-284 rifle with the Win chamber on it. I want to ream the chamber to a 6.5-284 Norma to use the better brass.
I have a few questions about this.
The neck it has is supposedly a "match chamber", but not a smaller neck diameter for turned brass. The barrel is only 26" now.
Should I set the barrel back enough to use a new tight neck chamber and lose about 1/2", or should I just have the Norma reamer run through and leave the neck like it is, then do a tight neck on a second set-back after some throat erosion?
Another question I have is, should I go with the Norma spec, or is there another variant of the 6.5-284 you recommend I attempt?
And finally, do you have any suggestions on who can perform the reaming?
Thanks
I have a few questions about this.
The neck it has is supposedly a "match chamber", but not a smaller neck diameter for turned brass. The barrel is only 26" now.
Should I set the barrel back enough to use a new tight neck chamber and lose about 1/2", or should I just have the Norma reamer run through and leave the neck like it is, then do a tight neck on a second set-back after some throat erosion?
Another question I have is, should I go with the Norma spec, or is there another variant of the 6.5-284 you recommend I attempt?
And finally, do you have any suggestions on who can perform the reaming?
Thanks