Search results

Hole in Garand receiver Can anyone advise the need/use for the hole in the RHS of the leg in a Garand ? did it help in the machining of the piece? i.e to hold in place to m/c other areas? how about the hole for the stud to make it go faster? i.e like a BM 59 select fire?

I forget to say that I found a table under Accuratshooter.com that gave some dimensions of other makes of primers :: CC! .118" , Fed .118 and .117" Rem .119" and win .121". grahame

I have done some measuring and fixing of my problem...I measured my primer pocket depth to exactly .130" I then measured 10 of my CCI #34 primers for seating depth , they varied in thickness from .1259 to 1.270"...since i cannot get my primer to seat fully i think to radius at the bottom of...

M1 Garand ,hole in Receiver Can anyone advise what the hole is for in the RHS rear leg of a Garand receiver Grahame

I solved my problem...it was the small radius at the bottom of the primer hole that was causing the bulged or not seated enough primer....But first , I measured my #34 CCI primers at an average over ten primers at 0.126"....I found on Accurateshooter.com an table giving primer thicknesses of ...

what I'm going to try is to chuck my RCBS pocket reamer into my mini lathe and then Dremel the face a little...hopefully this will dig into the radius at the base of the pocket. i.e to remove some of the tool chamfer.....it will taper more of the mouth of course...grahame

I think I know what my problem is...i just measured 10 primers #34CCI . they vary in depth from .1241" to .1270" Also I found a chart in Accurateshooter.com that shows primer depths of : CCI .118" , Fed .117" Rem .119" and Win .121". my prvi ocket measures .130" so seating...

prvi primer problem I've now purchased a Beretta BM 59 E again in 7.62x51... so now I really want to solve the issue... Grahame

prvi primer problem My Rifle is a BM 59 Beretta Mk1 ...can it slam fire ? I'm not happy taking the chance...Does anyone know of a primer pocker reamer that will remove the metal in the bottom radius of large primer pockets ?....i'm convinced that is my problem...I've searched all of the...

prvi primer problem ref this problem again....I measured the OD of the primer at .212" the primer thickness (depth)at .126" and the pocket depth at .130" So I tried the tapered reamer( mil crimp remover) then used the RCBS primer pocket tool....all a bit better but not quite....The...

I'm new to reloading 7.62X51 Nato...i've done .303 and .45acp before so i'm not quite a newcomer .....I bought some prvi 7.62x51 new brass and have trouble seating the primers ( CCI #34) not only difficult to get the primer in ( not all) but getting the primer all the way in....What I tried...