Search results

To answer your questions. The only time I use one shot is when I am going to load 50 cases, I then make sure that all cases have been hit with it from all directions, with the cases turned upside down. For smaller jobs I use either unique (hornady) lube in a tub, a little bit on the fingers and...

http://www.redding-reloading.com/techlinepages/bushingselection.htm

http://www.frfrogspad.com/bcdata.htm http://en.wikipedia.org/wiki/External_ballistics http://en.wikipedia.org/wiki/Ballistic_coefficient http://www.shootingsoftware.com/ballistics.htm#EBGC I have posted 4 links that will give you the more than enough information to answer your question...

A bullet with a high BC will travel farther than one with a low BC (see external ballistics). Since dense materials give more mass for a given volume or cross-section, bullets often employ lead in their construction, due to its low cost and relatively high density. When two bullets of the same...

Heres the link, http://www.hollandguns.com/ Looks to me like all they did is simplify the mil-dot system. Using MOA instead .

Ny factory tube started getting alot better after about 150 rounds. This link has some very good stuff on it. http://www.riflebarrels.com/support/centerfire_maintenance.htm

useful knowledge here Check it out http://www.riflebarrels.com/support/centerfire_maintenance.htm

Elvis Glad you feel better :D I have a Burris 4.5x14 Ballistic Plex on my primary deer rifle, I have tested the graduation from 100 to 300 yards, at 100 and 200 it is nuts on, but 300 it is off by 1 to 2 inches low. Point being I have tested it and practiced with it at those ranges. Your...

Tyler, I have checked the sites of Burris, Nikon, Bushnell, Simmons and Leupold, and all except leupold give parallax settings as 100 yards, this is for the burris fullfield, Nikon monarchs, Bushnell elite series 3200 - 6200, and the simmons Aetec. The 100 yard parallax free has been the...

OK, I think we have gone off the mark on this question. Elvis did bring up a good point parallax, most non parallax adjustable scopes are set for 100 yards, any further than that it seems to move the X hairs, and focus is a little fuzzy, so if that was the cause, then one would think group...

Randy please read question again, basically I do not believe wind flags whether with or without would matter for the question asked. Or do wind flags now change mathematics too.?

I was under the impression (remember new reloader here) that if my group size was 1" at 100 yards I could expect 2" at 200 yards and 3" at 300 yards and so on. Things are not always what they seem, 1" doesnt equate to 2" at 200, or 3" 300. all it means is that at 100 your rifle shoots and...

From wikipedia on Silencers. There are many benefits with suppressors on military rifles. Suppressors can increase the precision of a rifle, as they strip away hot gases from around the projectile in a uniform fashion. The suppressor can reduce the recoil significantly as it traps the escaping...

No quality does not suffer. Actually think it gives a more uniform end result.

Gilding metal is the softest type of brass commonly available. An alloy of 95% copper and 5% zinc, gilding metal is typically used for ammunition components. Copper is an excellent heat transfer metal, My thoughts are that what you are seeing over time is the cause and effect of temperature...

Bingo VG When considering the freight, powder and time to reform the 220 russian, it does make the Norma brass seem to be the best way to go.:D One thing I did read is that the Norma brass is considered to be less acceptable for BR due to the fact it doesnt hold up as well as the lapua 220...

After more research on this I think the answer to your question is that you need to expand the neck to accept .223 bullets instead of .220, after that it is nothing more than fire forming to blow out the case giving it less body taper and a shoulder angle of 30 degrees.

Riflemeister is only trying to make a good point, the regs can and will get the unknowing into trouble very quickly. Here if I let someone handle, fire, or otherwise transfer any weapon other than a muzzleloader without seeing thier firearms certificate, (our version of the local background...

AvanGorder here is a link for your question too much to explain here http://www.6mmbr.com/6PPC.html DD yes I have checked the Nosler brass, which is why I dont buy it anymore, weigh sorted RP brass comes in about the same per 100, I usually get 52 to 55 out of a bag that are within +-2 grs...

Riflemeister, You have just learned an important thing about this forum, watch how ya put things, even though the advice is good and sound, which yours was, Someone will put their sights on your backside and flame your tailfeathers faster than an F-16 shooting down a MIG, but at least they...