Action wrench needed

[chriscovell]

I have a Viper, Stolle Kodiak, and a Hall action. Is there a single action wrench that will work on all three? Looking for a rear entry, as two of them are left port and one is right. Thanks in advance, Chris.

[jackie schmidt]

I have a Viper, Stolle Kodiak, and a Hall action. Is there a single action wrench that will work on all three? Looking for a rear entry, as two of them are left port and one is right. Thanks in advance, Chris.

The Viper and Stolle will use the same rear entry wrench.

The Hall is an entirely different design.

[chriscovell]

Thank you Jackie!

[Wayne Shaw]

A Hall wrench is easy to make.

[chriscovell]

How is it easy to make?

[Wayne Shaw]

Hall has a full diameter bolt, so a steel round turned to proper diameter can be used. A flat will need to be milled on one end to fit where the lugs pass through ( this could be cut and filed if care was taken) and a flat on the opposite end to use a wrench on. Sounds harder than it is.

[liljoe]

I think Steve Theye from Benchrite has one on his table here at Holton.
I can ask him.
Joe Hynes

[Pete Wass]

like Wayne has described except I don't worry about getting into the lugs and use a shoulder bolt of proper size, to fit into the bolt slot. I mill a Hex on the aft end. I like the hex for using a socket on my torque wrench.

Pete