Search:

Bob thank you. I believe that is for trigger tech. I found them at wolf gunsprings.

Does anyone know where I can purchase a bolt release for a left hand remington 700 rifle? Thank you for any information.

I always use 215 or 215m primers in my 300 win mag rifles.

thank you all for your replies.

I recently installed pillars and bedded a McMillan drop in stock with devcon 10110. I used isopropyl alcohol on a q-tip to clean the epoxy around the receiver and it took the paint off the stock....

thank you Mram10

does anyone know for sure that the feed rails in a Remington 700 in 7mm rem mag are the same as one in 300 Winchester mag? thinking about putting a 300 win mag barrel on it. thank you

your last load listed is the max given in the 2017 hodg. annual manual with 130 gr. nos ab

im sorry if this has been posted . didn't see it. check it out. .282 inch 600yd 5 shot IBS group on 6mmbr daily bulletin.

you're welcome

https://www.eabco.com/BCChart.pdf put it in exactly like that.

card guns. for block and card shooting competition

i googled 25-45 sharps load data and several came up. interesting cartridge 223 rem necked up to 257. i didn't know of it until just now.

i always lube the dovetail with red shooters choice grease . if they get loose you can squeeze the dovetail in a mill vise and it will make it tight in the base. be careful if you do this as it does...

where can the felt pads be purchaser? thankyou

thank you for replying. i had checked the browning web site for specifications and it said nothing about having polygon barrel. i looked at it like you said and the lands are wide enough to make it...

i have a new production t-bolt and it appears to have a polygon barrel when looking at the crown. can anyone verify this? thank you.

first i'll say i'm not up to the class of the shooters on this site. i do load work for friends and my own rifles. mainly hunting rifles and a few tactical type guns. i cut my targets out of white...

a friend has a 338 lapua barrel off an ar type rifle and looking at the gas port with my bore scope it appears to be pretty rough with metal burrs in the bore. the muzzle side of the hole appears to...

thank you both for the reply. a great help this being the first time i have done this. i'm going to continue to play with this barrel and see what i can learn.

today i took a 000 buckshot and ran it down a .338 win mag barrel. i had a brass rod with a tip that sat on the lead ball like a shot glass on a baseball, a set up that would keep the rod off the...

in the late 60's i had a glass bedded 700 adl in 243. with the cheapest federal high shocks it would shoot 3 shot 3\4 inch 100yd groups with 100gr. bullets and several of other deer rifles through...

i would certainly try the 4198 like Gerry said. just because sierra gives 748 as their accuracy load means nothing in your gun.

3200 fps

don't have one. sierra book gives for the 60&55gr. accuracy and hunting load 28.2 gr of 748 this is .8 grains below max. all these are max reduce 10 percent to start. and all 3200 fps in a 24 inch...