Search:

Scrape metal market in Ukraine is kinda flooded= Low prices. So second option looks more promising- all you need is a small excavator of some type. Plenty of holes to fill, which adds a third option.

might try,if you haven't already, 41L40 ( 4140 with lead added to increase production and tool life- heat treatable as well)

i have a couple of the skytron 36x scopes work fine for me.

good info on the knife vs laser and medicare, thanks, 71 and cats are getting in the way some. about the only thing left eye is good for is depth perception, brain doing the auto compensation thing -...

sorta remember no electronic triggers/ valve system as being in the rules also.

might try warming it up real good with a hair dryer or similar. there might be some type of lock tight on the threads.

particulaerly since the new formulation. #9 was the go to stuff for grenerations, for me the scent brings back many memories.

boy i remember both my sons sitting on my lap pulling the loader handle for me as i was assembling match ammo for full course shoots as well as shotgun rounds.

commercial pellets are swagged, not cast. Got to be a nightmare trying to cast 8-14gr pellets with a hollow base. yes, there are solid base pellets but you need those to be dead on and dead soft for...

old material will sometimes turn out that way. it might be quite awhile before it fully cures. there are mixes that get hard to a pliable state in about 4-8 hours but full cure will not be reached...

Butch in addition the stand alone compressors there are booster units that run off air supplied by a standard compressor- not that they are any real saving dollar wise but less failure rate than the...

maybe the nut you got is not Acme ( not typically found in hardware stores) then there is the possibility that, if it was ordered, it was picked wrong or packaged wrong. (or it is a 12 count...

not so crazy beats sweeping those pesky grass clipping

my question is , regaedig the extreme dude, if unemployed -who the .... is paying for all this.

D's are single shot, I believe that the factory sport class requires a magazine, D's & the Elusive E's do not have such.

What no clenched teeth , tongue twisted up, shaking hands and sweating forehead- geez all the fun's gone out this.

Pellets are almost pure lead- very soft. Easy enough to make a push through sizer out of a bit of tool steel. Course I have a small machine shop which gives a bit of an advantage in that department....

over my term here on earth I have seen a lot of various "factory " class rules. Same with "sporter" . The over all problem is how far one can bend / strech the rules.
There are 2 types of 52c's...

had one for many years. Alas I drifted to the dark side, first co2 then pcp- mostly because of getting into benchrest at 25 meters and beyond. For its intended purpose it is as good as anything else...

that is an extremely rare occurrence. congratulations.

mineral spirits another choice ( basicly Stodard solvent - parts cleaner)

pellet seating tool- at one time marketed by Beeman. one end a bit pointed other a round ball, flared skirt out a bit or if deformed round it back out a bit.
flat tray refered to was a sorting...

likely the best thing you can get would be the daisy 753s - this is a single stroke/pump pneumatic rifle not a springer. Springers are notoriously difficult to shoot off a bench. Designed for 10...

at what distance? 50 Meters ? or 15 meters ( 50ft) ? having played in both areas smallbore.

that same stuff is contained in hr 5717 ( I think that is the right #)