brickeyee
Registered User

Vic, you guys are just kids!

Time to buy a new gun.

I would give RCBS a call. You might even need to send them a drawing of the chamber. They used to be very good at this. They have a wide stock...

I used to make and sell case forming dies. I have reduced 458 Lott to 224. Needs to be in steps of .030. Don't worry about shoulder angle as your...

"OLE Woody, I'm glad that he is gone. Jackie Schmidt thinks and I concur that it is a PH type stainless. Got to use a lot of speed and feed.

So what kind of a curve does the bore wander off to?

Length is fine- the knob is terrible.

Yes sir.

Tony, a nice looking rifle and a God awful bolt knob. IMHO

You need to add Stan Taylor-2022.

The "Gordy" method. I've never been warm and fuzzy doing it that way Al.

I have seen a couple steadies as Dave has mentioned. It is probably a minor measurement, but how close can the muzzle be in the 4 jaw? Are you going...

Sorry, I messed up, but corrected it. You are using the gordy method. Oh well.

So, how do you indicate the bore in the muzzle end that is in the 4 jaw. Maybe you're using the gordy method?

Anything that changes the length of the lever arm will alter the torque reading. Even a straight extension that is at an angle. If you make sure...

Lawrence, thanks for this.

A problem with measuring at the firing line is that it is a only a single point in the trajectory. I like shooting over grain crops. You can look...

Yes sir, I know, I was just stating Stan's thoughts as it led up to his heart attack.

Seems his sick feelings were a week or so ago and his initial thought was bad tuna fish.

http://www.neiljones.com/html/target_measuring.html

Great shooting Mike.