Dave Tooley
Registered User

AL, I'd use a spider instead of the 4 jaw. Easier to adjust with the screws vs the chuck jaws.

Al, I've seen a custom built steady using a high grade bearing instead of fingers with a spider built in. I seem to recall it was used for shotgun...

I know Jef Fowler had over a million on his carbide 6MM dies. They were getting a bit fat and fish mouthed.

You can make a lot of bullets with steel dies. I started with a 6MM set Ferris made. To wear out carbide dies takes numbers around a million or more....

A simple search on this site. https://www.accurateshooter.com/competition/new-scoring-reticle-approved-by-ibs/

No it wasn't. I sent all my measuring equipment off and there was a card in the box with the reticle. He made a run a few years ago because of new...

I don't have his contact information but a gentleman was making a scoring plate, all calibers, for the IBS. All you need is a 4X domed magnifier to...