skipkh
Registered User

Ahh... ok then I must be using his method to chamber because I do the same. I guess I owe Gordy a check for using his method : ) Thanks for...

I guess I'm unclear on the difference between chambering with a chuck and spider (either outboard or spider in the steady) to dial out runout and to...

It's been my experience that this is not typically achievable. The bore isn't straight on most barrels. If you dial in the muzzle then the chamber...

Hi Butch! Glad you chimed in : ) Muzzle end goes in the 4-jaw. Breech end rides in the spider located in the fingers of the steady. Indicator...

That's an excellent tip! I can place the set screws where the proposed leade would be in this design very conveniently. I can also see two pivot...

thanks for the lead! I'll try to hunt down the video. Yep - I use 4g copper wire in the 4-jaw when I chamber in the headstock, so planning the same...