Results 1 to 8 of 8

Thread: Action wrench needed

  1. #1
    Join Date
    May 2018
    Posts
    14

    Action wrench needed

    I have a Viper, Stolle Kodiak, and a Hall action. Is there a single action wrench that will work on all three? Looking for a rear entry, as two of them are left port and one is right. Thanks in advance, Chris.

  2. #2
    Join Date
    Feb 2003
    Location
    Houston, Texas
    Posts
    7,003
    Quote Originally Posted by chriscovell View Post
    I have a Viper, Stolle Kodiak, and a Hall action. Is there a single action wrench that will work on all three? Looking for a rear entry, as two of them are left port and one is right. Thanks in advance, Chris.
    The Viper and Stolle will use the same rear entry wrench.

    The Hall is an entirely different design.

  3. #3
    Join Date
    May 2018
    Posts
    14

    Thank you

    Thank you Jackie!

  4. #4
    Join Date
    Feb 2003
    Location
    VA
    Posts
    907
    A Hall wrench is easy to make.

  5. #5
    Join Date
    May 2018
    Posts
    14

    hall wrench

    How is it easy to make?

  6. #6
    Join Date
    Feb 2003
    Location
    VA
    Posts
    907
    Hall has a full diameter bolt, so a steel round turned to proper diameter can be used. A flat will need to be milled on one end to fit where the lugs pass through ( this could be cut and filed if care was taken) and a flat on the opposite end to use a wrench on. Sounds harder than it is.

  7. #7
    Join Date
    Feb 2003
    Location
    Mt Pleasant Michigan
    Posts
    372
    I think Steve Theye from Benchrite has one on his table here at Holton.
    I can ask him.
    Joe Hynes

  8. #8
    Join Date
    Nov 2006
    Location
    Augusta, Maine & Palm Coast, Fl
    Posts
    5,656

    I have made a few

    like Wayne has described except I don't worry about getting into the lugs and use a shoulder bolt of proper size, to fit into the bolt slot. I mill a Hex on the aft end. I like the hex for using a socket on my torque wrench.

    Pete
    Last edited by Pete Wass; 09-16-2018 at 06:39 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •