Results 1 to 5 of 5

Thread: 2500X action?

  1. #1
    Join Date
    Feb 2013
    Location
    PA
    Posts
    44

    2500X action?

    When bedding the 2500X do you pillar all 3 action screws? Would you put a block of some kind in the stock for the cut out on the bottom? Or just bedding material?

    What are the extra holes for ... one in front of trigger group screw unthreaded and another aft of the front action screw and threaded?

  2. #2
    Join Date
    Aug 2015
    Location
    Ohio - Land of the "Mogs"
    Posts
    82
    My Trident and 2500x... the lug is in bedding. (10mm “cutout”)
    One stock has all three screws and the other utilizes two.
    (FYI... a Lidgard stock from Dan will have provisions for two action screws)
    The small tapped hole (6-32?) is under the loading ramp. And was meant to allow for the adjustment of the ramp. Jerry’s tolerances are such that it is most likely design overkill. Nevertheless options.
    The untapped hole... call Jerry.

  3. #3
    Join Date
    Feb 2013
    Location
    PA
    Posts
    44
    If I understand correctly...you have a 10mm block bedded in your stock?

    Thank you for the information

  4. #4
    Join Date
    Aug 2015
    Location
    Ohio - Land of the "Mogs"
    Posts
    82
    My apologies for being misleading. No. The bedding created a 10mm lug.
    The bedding work was done by two different people. (Not I)

  5. #5
    Join Date
    Feb 2013
    Location
    PA
    Posts
    44
    Okay
    Understood.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •