Results 1 to 6 of 6

Thread: Changing neck tension

  1. #1
    Join Date
    May 2003
    Location
    Balto., MD
    Posts
    569

    Changing neck tension

    If you have a load worked up and decide to try going down .001 on the neck bushing should you change anything else? Back down the powder? Leave everything else alone? Or start load development all over? The load in tune now isn't a max load but probably within .5 to 1 grain of max.

  2. #2
    Join Date
    Dec 2003
    Location
    washington.........STATE that is.
    Posts
    10,970
    I change only one thing at a time

  3. #3
    Join Date
    May 2003
    Location
    Balto., MD
    Posts
    569
    So then is it better to retune with seating depth or powder?

  4. #4
    Join Date
    Feb 2003
    Location
    USA.
    Posts
    200
    Leave everything else alone & test fire a few rounds.

  5. #5
    Join Date
    May 2003
    Location
    Balto., MD
    Posts
    569
    I got that part, but if it isn't any better or it's worse, then where from there?

  6. #6
    Join Date
    Feb 2006
    Location
    Wilcox, PA
    Posts
    249

    Check carefuly always

    Quote Originally Posted by rflshootr View Post
    i got that part, but if it isn't any better or it's worse, then where from there?
    check cases after fire forming then set sitting depth powder charge look in book for most acc load also right bullet

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •