Results 1 to 4 of 4

Thread: Need bedding help on suhl 150

  1. #1
    Join Date
    Jan 2019
    Posts
    18

    Need bedding help on suhl 150

    I am currently trying to pillar and devcon my action but I am having no luck getting the loading ramp/single shot adapter out. I removed the clip holding the ejector in and the ejector will move up some but not all the way out. When I do that the rear of the loading ramp will come up a little bit but not much while the end near the barrel is still quite snug. Any help or suggestions would be greatly appreciated.
    Last edited by Saigashooter; 03-04-2019 at 01:25 PM.

  2. #2
    Join Date
    Nov 2006
    Location
    Augusta, Maine & Palm Coast, Fl
    Posts
    5,988

    you might try asking

    on the Rimfire forum.

    Pete

  3. #3
    Join Date
    May 2012
    Posts
    44
    Quote Originally Posted by Saigashooter View Post
    I am currently trying to pillar and devcon my action but I am having no luck getting the loading ramp/single shot adapter out. I removed the clip holding the ejector in and the ejector will move up some but not all the way out. When I do that the rear of the loading ramp will come up a little bit but not much while the end near the barrel is still quite snug. Any help or suggestions would be greatly appreciated.
    There is a tab in the front of the loading ramp that fits into a cutout in the bottom of the barrel. Once you remove the clip and the pin off, you can use a thin blade screw driver, and try to push the loading ramp back, there is a lot of crud that accumulates in that area, so it may take a little effort to push it back, should come right out.
    Evelio.

  4. #4
    Join Date
    Mar 2017
    Location
    Westchester NY and Delray FL
    Posts
    107
    Quote Originally Posted by Saigashooter View Post
    I am currently trying to pillar and devcon my action but I am having no luck getting the loading ramp/single shot adapter out. I removed the clip holding the ejector in and the ejector will move up some but not all the way out. When I do that the rear of the loading ramp will come up a little bit but not much while the end near the barrel is still quite snug. Any help or suggestions would be greatly appreciated.

    Try pushing the loading ramp down with your finger while tapping the ejector out as far as it will go.
    If the ejector still wont come out, while still pushing the ramp down with your finger, reach in with a needle nose pliers and gently wiggle , jiggle and pull until it comes out. The loading ramp should come out with a little gentle persuasion.

    Bob

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •