Search:

Type: Posts; User: n.r.davis; Keyword(s):

Search: Search took 0.07 seconds.

  1. Replies
    5
    Views
    985

    Just a guess but if whoever Bead Blasted the...

    Just a guess but if whoever Bead Blasted the outside put Steel Hooks in the bore to hold it while blasting and those Hooks had rough saw cuts on the ends I could imagine that kind of damage. David
  2. Replies
    12
    Views
    2,576

    Got the barrel off last night after a week of...

    Got the barrel off last night after a week of coaxing. Now the fun begins! David
  3. Replies
    9
    Views
    1,381

    Good news as the barrel came off last night. I...

    Good news as the barrel came off last night. I use a Heat Gun to warm the receiver to where spit will sizzle, spray penetrating oil and set up a vibration with a hammer. Took a week of doing that. ...
  4. Replies
    9
    Views
    1,381

    Thanks for the advice. I have it locked in the...

    Thanks for the advice. I have it locked in the vice with the Action Wrench leaning to the left with a weight on it. I will gently tap it and use Ed's Red on it every time I pass by. Want to save...
  5. Replies
    9
    Views
    1,381

    Pulling the barrel on a Sake L46

    Short story is it won't come loose. A Dead Blow Hammer on a 3 foot bar doesn't do anything. I figure it may have been together for almost 60 years so for now I will Soak it and keep trying. Any...
  6. Thread: 700 Triggers

    by n.r.davis
    Replies
    13
    Views
    1,799

    O.K. going to suggest that you check the fit of...

    O.K. going to suggest that you check the fit of the Pins. For my own rifles and those are the only ones I will work on the trigger, I make new pins that are a "tap in fit" and then Lap out the...
  7. Replies
    12
    Views
    2,576

    So Murphy raised his ugly head. Brass won't...

    So Murphy raised his ugly head. Brass won't chamber, and the extractor won't snap over the groove. Trying to pull the barrel as I can see where the extractor is rubbing on the end of the barrel and...
  8. Replies
    12
    Views
    2,576

    Still figuring out what this rifle will do. ...

    Still figuring out what this rifle will do. Thanks for the information. I am wondering if 62 gr bullets will shoot out of it. So far I have taken the mounts apart, packed with old hard grease. ...
  9. Replies
    12
    Views
    2,576

    Thanks for the Information. I just ordered some...

    Thanks for the Information. I just ordered some Brass and will as time permits see what works. Miss Precision Shooting as there was no B.S. in the articles. First on the list is a Chamber Cast. ...
  10. Replies
    12
    Views
    2,576

    Vintage Benchrest or Target Rifles

    I went looking for a Lyman STS Scope and found one attached to a Sako Single shot Rifle in .222 Mag. So I got the whole package and it sparked an interest in what was State of the Art back in the...
Results 1 to 10 of 10