Tab Content
  • brickeyee's Avatar
    12-08-2018, 03:37 PM
    I used to design welding procedures in glove boxes (some rather large ones) to completely control the welding environment. I allows welding on...
    27 replies | 2528 view(s)
  • brickeyee's Avatar
    12-07-2018, 03:39 PM
    You seem tyo have no idea what you are doing. If you wanted to attempt to weld a barrel foot on a 1911 barrel the welding is occurring on the...
    27 replies | 2528 view(s)
  • brickeyee's Avatar
    12-04-2018, 02:07 PM
    Making precision measurements takes a very light touch. And for even higher precision a defined touch from a spring on one side of a measuring...
    42 replies | 2584 view(s)
  • brickeyee's Avatar
    12-02-2018, 04:27 PM
    You are purging the interior of the barrel. It does not matter since you are welding on the exterior of the barrel.
    27 replies | 2528 view(s)
  • brickeyee's Avatar
    11-27-2018, 05:14 PM
    Threads are normally only cut in ONE direction. It does not matter as long as the lead screw comes to the same position when you start cutting each...
    21 replies | 5303 view(s)
  • brickeyee's Avatar
    11-27-2018, 05:05 PM
    Purging with a more stable gas without oxygen (nitrogen is usually good) only prevents surface scale formation (iron oxides mainly). Any hardening...
    27 replies | 2528 view(s)
  • brickeyee's Avatar
    11-19-2018, 05:56 PM
    Since you only cut in one direction it is not all that important actually. As long as it tightens up the same way each time it engages and the...
    21 replies | 5303 view(s)
No More Results
About brickeyee

Basic Information

Statistics


Total Posts
Total Posts
389
Posts Per Day
0.08
General Information
Last Activity
12-12-2018 01:23 PM
Join Date
07-15-2005